ADAPTEC ATA RAID Card PCI ATA 100 2 Channel | 1200A / AAR-1200A Kit | 1891200

Item is used and only ** PARTIALLY ** tested -- see pictures. Item comes **AS PICTURED** and does NOT include: Two Internal 40-pin, 80-wire ATA/100 Cables Driver Diskettes - Though the drivers ** MAY ** be on the CD Any Type of Follow-Up Support This Card's Serial # -> HX0A51202MH Features -> RAID RAID Levels 0, 1, 0/1 & JBOD 48-bit LBA Supports Drive Sizes Larger Than 137 Gigabytes Supports Bootable Arrays Hot-Spare Disk Support Hardware Two ATA/100 Channels Supports up to Four ATA/100 or ATA/66 Drives Up To 100 MByte/sec Transfer Rate Per Channel [ 32-bit, 33 MHz ] Configuration & Management Software BIOS Configuration Utility Adaptec Management Console for User-Friendly RAID Configuration & Monitoring Testing The testing setup consisted of a BIOSTAR TA-7050M2 Motherboard booted from a SATA drive running a fully patched Windows 10 Operating System. The card was seated into a PCI slot without any drives attached and the system booted. System booted into controller's BIOS - Control-H key combination entered into the Configuration Utility. Since there were no disks attached to the controller, rebooted and let the system boot normally. Allowing the system to continue booting into the host OS, the adapter was ** PARTIALLY ** recognized as Unidentified Mass Storage Controller. Item is ** NOT ** Plug-N-Play compatible with Windows 10. Kit Contents -> Adaptec ATA RAID 1200A Card Adaptec ATA RAID Management Software Installation Manual E4468